|
Fixing:
1. If fixing to a structure, pre-drill fixing holes to allow for expansion and contraction. (Use a 10mm drill for lengths up to 4.2m and a 12mm drill for lengths longer than 4.2m.)
2. Fix the material into place with screws and sealing washers.
3. Fix the panels every 200-250mm around the perimeter.
4. Screw cover battens to the frame every 300-325mm.
5. Remember to use Laserlite fixings, as these are compatible with Premium Polycarbonate and PVC.
Tools required
Handiglaze is sawable, drillable, bendable (to a radius of 50mm).
Cutting:
Multipurpose tinsnips or fine tooth saw.
Drilling:
Blunt metalworking drill on a slow speed. Note: Support must be given during cutting and drilling.
Cleaning:
Use soapy water (mild detergent). Avoid abrasive cleaners.
Gluing:
Not recommended.
Sealing:
Use any adhesive or sealant suitable for PVC plastics. Should only be used to affix Handiglaze to itself or other PVC materials. Clamp the joint for 24 hours. Note: Some adhesives may cause brittleness - test first.
Bending:
Apply indirect heat to the area to be bent, and then bend the sheet. To remove white marks, apply further gentle heating.
Handling & Storage
When storing Laserlite Handiglaze before installation, be careful to keep the rolls away from direct sunlight and moisture, which can damage the roll.
|
